Programming instructions

24
A number of steps have to be
executed for commissioning the
DCIP 650-... . The specied sequence
must be adhered to without fail.
• Prior to programming the
DoorCom IP 650-... the entire
In-Home system must be pro-
grammed and documented with the
bus programming software
BPS 650-... .
• Complete programming of the
DoorCom IP 650-... takes place
using the bus programming software
BPS 650-... via the SII 650-...
6 Commissioning
DCIP 650-01
Connection of the PC to SII650-...
Step 1
Issue of the IP address and
subnet mask in the IPVS600‑...
• The connection can be established
using a crossover network cable. The
IPVS600-... can also be addressed
via the network if the PC and
IPVS600-... are located in the same
address area.
• Start the Internet Explorer on the
PC and enter the following in the
address line:
http://192.168.0.1
The IP settings in the as-delivered
status of the IPVS 610-...
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Gateway address: 0.0.0.0
User name: Service
Password: None issued on
delivery
The user interface is opened.
• Select the Expert mode menu
item.
• UnderExpert mode select the
menu point Network
• The following settings can be
performed for operation in the
network:
DHCP
IP address
Subnetmask address
Gateway address
DNS server address
Changes to the IP address, subnet
mask address or gateway address
are transmitted to the device by
clicking on the Set button. However,
these only become valid after
restarting the device.
• After entering a new IP address,
click onto the Set button
• Enter the old IP address in
the address line of the web
browser, followed by /reset (e.g.
192.168.0.11/reset). The IPVS 600 is
restarted and can subsequently only
be reached using the new IP address.
The connection is established
between the PC and IPVS 600 ... .
Changes to the IP address or subnet
mask address are transmitted to the
device by clicking on the Set button.
However, these only become valid
after restarting the device.
• After entering a new IP address,
click onto the Set button.
• Enter the old IP address in the
address line of the web browser,
followed by /reset (for example
192.168.0.1/reset). The IPVS is
restarted and can subsequently only
be reached using the new IP address.
Step 2
Read out In-Home bus
All existing devices within the
In-Home bus are read in and are
then visible in the BPS650-... as a
tree structure. Each BVNG650-...
possesses a unique address. This
must be set the same at the
SII650-... and SIVS610-... .