Programming instructions

13
f
ij
gh
a bc d
e
5 Installation wiring diagrams
Terminals DCIP 650-01
Terminals and LEDs IPVS 600-01
a 12VDC power input for
connecting the power supply
b Connecting socket to the
SIVS610-...
c LED LINK lights up in green with
an existing network connection
d RJ45 socket ETH network
connection
e LED ACT lights up in orange on
data transmission via the network
Terminals SIVS 610-...
a Video signal 1 Vss (cinch jack)
b Terminating resistor 75 Ohm
ON/OFF
c IN = video signal 1 Vss input,
D =video signal 1 Vss throughput
d Terminals for installation
e Connection to IPVS 600-...
f Terminals for installation
g Grounding terminal
h BCD rotary switch for the In-Home
bus line address
Terminals and LEDs IPVS 600-01
f Video input 1 Vss from the
SIVS 610-...
g Card slot for SD
TM
card
(no function)
h Audio-Line-In/Audio-Line-Out to
the SIVS 610-...
i LED operating status lights up in
green on readiness for operation
j Reset button to recreate the as-
delivered status (after a reset, the
Siedle modes must be reinstalled,
see Chapter Factory reset.)