User`s guide

- 30 -
Removing the Battery Pack
1. Remove the battery cover as shown in Figure 1.
2. Pull out the battery pack, grab the connector with your thumb and
index finger, and remove it by pulling up on it.
3. Close the battery cover.
Figure 1 Figure 2
Charging the Battery pack
1. Connect the AC adapter to the printer.
2. Turn on the printer. The Power LED will blink once every second
indicating the battery pack is charging.
It takes about 10 hours to fully charge the battery pack.
When the battery pack is fully charged, the Power LED stops
blinking and goes on.
3. Disconnect the AC adapter.
 Always charge the battery pack in a location that is from 5 C (41
F) to 40 C (104 F) otherwise it may lead to a degradation of the
battery pack.
 The printer does not charge the battery pack when the power is in
OFF state.
• Battery charging is temporarily disrupted while the printer is
printing and resumed automatically when printing is completed.
NOTE
HINT