User`s guide

-
29 -
SWDIP switch 4
SW
DIP
Function Setting
1 Disable
4-8
Bluetooth Link Key
selection
*4
(Bluetooth Link Key)
0 Enable
4-7
Reserved
1 Fixed to 1
1 Busy
4-6
Busy Output When
Error Occurs (Error)
0 UnBusy
1 Disable
4-5
Mark Position
Correct
*1
0 Enable
4-4 0 0 1 1
4-3
Bluetooth Baud
Rate
*2
0
230400
bps
1
57600
bps
0
115200
bps
1
230400
bps
1 Disable
4-2
CTS Control
0
Enable
1 Disable
4-1
Auto Activation by
AC
*3
0
Enable
*1 : When Paper Mode of SWDIP switch 3 is set as Mark Roll Paper, the printer operates paper
feeding to backward approximately 5 mm just before printing process after operations such as the
power on, resetting, FEED switch or page feed. If the function sets to Enable, be sure to send
printing pattern that is longer than 5 mm. If the function sets to Enable while using the label
paper, the length of label should be 40 mm or longer.
*2 : This setting is enabled only the Bluetooth-supporting model. Generally, select Bluetooth baud
rate to 230400bps.
*3 : If this setting is enabled, the printer turns on automatically when the AC cable of the AC adapter
inserts to the outlet.
*4: Bluetooth-supporting model only. If this function is set to Enable, the printer saves the link key for
Bluetooth connection. Saving the link key can connect to the host device without PIN code
authentication.
Even if PIN code is not specified in advance, the printer processes PIN code as '0000'.