User`s guide

-
19 -
4 PAPER SETTING
This printer can feed cut paper and paper roll. The printer function setting for cut paper
is different from that for paper roll. See Section 6 Function Setting for details.
 Setting Cut Paper
(1) Turn the printer on.
(2) If the printer has been stored without
thermal paper, open and close the
paper cover (see Section 2 EACH
PART OF PRINTER) before setting the
cut paper.
(3) Insert the cut paper into the paper slot in
the printer until it stops with its printable
surface facing down.
(4) The printer detects the thermal paper
and loads it automatically.
(5) To discharge the thermal paper from the printer, hold down the FEED switch.
CAUTION
 Take care not to get your fingers caught in the printer when loading the
thermal paper.
NOTE
- Insert the thermal paper into the paper slot straight. If it is askew, a
paper feed error occurs.
- DO NOT block the paper outlet or hold the thermal paper that is being
loaded. Otherwise, it may cause a paper jam.
HINT
 Marks for paper position detection are printed on the back of the
specified paper. When the printer detects the mark, it enters print-ready
mode.
 If the printer does not detect a mark, the ERROR lamp blinks. Press the
FEED switch once or turn the printer off and on again to clear the error.
Place a cut paper with the paper
position detection mark facing up.