User Manual
EN
EN - 9
INSTALLATION
Removing the transport screws
1. Remove the 4 transport screws and
rubber washers from the rear of the
washing machine before putting
it into operation. If the screws are
not removed, they can cause severe
vibration, noise and malfunctioning of
the washing machine and may void
the warranty.
2. Loosen the carriage bolts by turning
counterclockwise with a suitable
spanner.
3. Remove the transport screws by
pulling them out directly.
4. Insert the plastic plugs supplied in the
accessory bag into the holes left after
removing the shipping screws. The
shipping screws should be stored for
future use.
Note:
Remove the transport screws before using the washing machine for the
Adjustment of levelling feet / adjustment of adjustable stops
1. Do not install the washing machine on
a surface (e.g. carpet) that prevents
ventilation from below.
• To ensure quiet, vibration-free
operation, install it on a solid surface.
You can level the washing machine
with the adjustable feet.
• Loosen the plastic lock nut.
2. To raise the height of the washing
machine, turn the feet clockwise.
To lower the height of the
washing machine, turn the feet
counterclockwise.
• Once the washing machine is in
a horizontal position, tighten the
locknuts by turning clockwise.
3. Never line the washing machine with
cardboard, wood or other similar materials.
•
take care not to disturb the horizontal position of the washing machine.
X X4 4
X
4
1
3
2
4
1
X4
2 3