User Manual
EN
EN - 10
Electrical wiring
• The washing machine requires a mains
power supply of 220 -240 V, 50 Hz.
• The power cord of your washing
machine is equipped with a grounded
plug. This plug should always be
plugged into a grounded 10 A socket.
• If you do not have a suitable socket
• We are not liable for any damage caused by connecting the appliance to an
ungrounded socket.
Note:
Operating the washing machine at low voltage leads to shortened life and
reduced performance
Hose for water supply
1.
the washing machine, your washing
machine may be connected to a cold
water supply or to a cold and hot water
supply. The white capped hose should
be connected to the cold water supply
and the red capped hose to the hot
water supply (if available).
• To prevent water leaking into the
joints, 1 or 2 nuts are supplied with the
hose (depending on the model of your
washing machine). Place these nuts
on the end of the supply hose that
connects to the water supply.
2. Connect the new supply hoses to the
¾ thread tap.
• Connect the white end of the supply hose to the white inlet valve on the back of
the washing machine and the red end of the hose to the red inlet valve (if used).
•
•
3. Once you have made all the connections, turn on the water supply and carefully
check for leaks.
4. Ensure that the new water supply hoses are not pinched, kinked, twisted, kinked or
kinked.
• If your washing machine is connected to a hot water supply, the temperature of
the hot water supply should not exceed 70 °C.
Note:
The washing machine must only be connected to the water supply using
the new supply hose supplied. Old hoses must not be reused.
3/4"
10 mm
1
3
2
4