Instruction Manual
EN - 9
On / Off / Vibration speed selection
button
1. Briey press the on/off button and the brush will
turn on. You will hear one beep and the light will
come on. The brush starts at low vibrations.
2. Press the on/off button again to start the brush on
high vibration.
3. If you press the on/off button again, the brush will
turn off and the light will turn off.
Use
1. Wet your face and apply a little cleansing gel/
cream to the areas you will be cleaning. Make sure
the gel/cream is spread evenly see pictures A1 on
page 4.
2. Press the on/off button to turn the brush on
and select low/high vibration (see previous
paragraph).
3. The brush will run for 2 minutes and every 20
seconds the brush will pause for 1 second to
remind you to move the brush to a different spot
on your face. The brush will automatically turn
off and the lighting will go out after 2 minutes of
operation.
4. Move the brush across the face in a circular
motion from the inside out see gure A2 on
page 4. Do not press on the brush so as not to put
too much pressure on the skin and damage it.
5. After cleaning is complete, press the on/off button
repeatedly until the brush turns off.
6. Wait for the brush to come to a complete stop
and clean it according to the instructions in the
"Cleaning and maintenance" section.
CLEANING AND MAINTENANCE
Always switch off the appliance and wait for the
brush to come to a complete stop before cleaning or
any maintenance.