Instruction Manual

EN
EN - 8
Installation instructions
The minimum distance between the surface of the hob and the lowest part of the
hood is 65 cm. The range hood is designed both for extraction into the chimney and
for air recirculation.
We recommend that two adults perform the installation.
1. Chimney ue
The fumes are vented out of the building using a suction pipe that is connected to a
non-return valve at the top of the hood. The diameter of the suction pipe must match
the diameter of the non-return valve. The suction pipe is not included in the package.
If the range hood has been used with a carbon lter, it must be removed if it is to be
used again with a chimney ue.
2. Recirculation
During recirculation, air is discharged back into the room. The intake air is degreased
and deodorized, and is then discharged back into the room.
A carbon lter must be installed before using the hood in this way.
Installation
1. Cut a hole of the appropriate size in the cabinet
where you will install the cooker hood.
Note:
The depth of the cabinet must not be less than 26
cm. A free space of 5 cm must be left at the front
and back.
2. Loosen the four screws of the front panel,
remove the decorative frame and slightly
tilt the front panel to disconnect the cables.
After disconnecting, put the front panel and
decorative frame aside.
3. Loosen the screws of both xing washers, which
are located on the sides of the cooker hood.