Instruction Manual
EN
EN - 5
appliances that only discharge air back into the room.
11. The minimum distance between the surface of the hob and the lowest
part of the hood is 65 cm.
12. Follow the regulations regarding venting the extracted air.
13. This range hood is only intended for installation above a hob with a
maximum of four cooking zones.
14. Follow the installation instructions in this manual.
15. Use the supplied mounting kit or a kit recommended by the
manufacturer to attach the range hood.
16. WARNING: Incorrect installation of screws or attached devices specied
in the instructions may result in an electrical hazard.
17. The range hood is designed to extract steam and vapors during cooking
in the home. Do not use it in a commercial establishment. Do not use it
for purposes other than those for which it is intended.
18. Before connecting the plug of the power cord to the mains socket, make
sure that the voltage on the rating plate corresponds to the voltage in
your socket.
19. Connect this range hood only to a properly grounded outlet. Do not use
extension cords, portable extension sockets, adapters or other similar
devices.
20. Switch off the hood and disconnect the power supply plug whenever you
clean it, change the lighting, assemble or disassemble it.
21. When replacing lighting, always use the same type of uorescent light
specied by the manufacturer.
22. This range hood cannot be used as a support surface.
23. If the hood is damaged, contact an authorized service center to have
it repaired. Never repair it yourself. There is a risk of injury from electric
shock.
Lighting specications
Type of uorescent light: L10
Shape: square
Rated power: 2 W