Instruction Manual

EN
EN - 13
1. Remove the front panel and carefully remove the grease lter.
2. Wash the grease lter in warm water with a little dishwashing liquid.
3. Rinse and wipe dry.
4. Install in place and replace the front cover.
Warning:
Before installing the grease lter, make sure it is completely dry.
Note:
You can wash the grease lter in the dishwasher. Place it vertically in the
upper basket to increase washing efciency. However, the water tempera-
ture should not exceed 65 °C.
Carbon lter replacement
Note:
Do this step if you are using the recirculation method.
The carbon lter absorbs unpleasant odours from cooking. Its saturation occurs
through long‑term use, intensive cooking and regular cleaning of the grease lter.
We recommend changing the carbon lter every 3 months.
1. Remove the front panel and carefully remove the grease lter.
2. Turn the carbon lter counterclockwise to loosen it and carefully remove it.
3. Insert the new lter on one side of the motor unit and turn the lter clockwise to
secure it. Make sure the lter is installed correctly. Improper installation can cause
abnormal noise and vibrations, which can lead to damage to the hood.
4. Install the grease lter and front panel.
Warning:
The carbon lter must not be washed.
Light replacement
1. Switch off the hood and disconnect it from the power socket.
2. Loosen the screws of the lighting cover and carefully remove the cover.
3. Unscrew the uorescent light.
4. Insert a new uorescent light of the same type.
5. Replace the cover and fasten with screws.