Instruction Manual

EN
EN - 12
1. Slide the cover with the battery compartment from the bottom of the remote
control.
2. Remove the depleted battery and insert a new 3V CR2032 battery. Observe correct
polarity when inserting a battery.
3. Insert cover with the compartment back into the remote control.
If you will not use the remote control for a long time, we recommend removing the
battery. If the battery leaks into the interior of the remote control, it could damage it.
Warning:
Never put batteries in re, short circuit or damage them in any way. After
the end of their lifetime, discard them in environmentally friendly man-
ner. Never dispose of batteries in household waste.
Pairing the remote control with the cooker hood.
1. While the hood is off, press the
button for 2 seconds, the indicator starts
ashing and a beep sounds.
2. Press any button on the remote control and a beep will sound. The light will turn
off and the pairing has been completed successfully.
3. If you do not press any button on the remote control within 3 seconds, the light will
go out and the hood will turn off.
Note:
Pairing only needs to be done once before rst use, or if the internal
memory of the hood has been cleared.
CLEANING AND MAINTENANCE
Always switch off the appliance, disconnect the power cord plug from the mains sock-
et prior to cleaning or any maintenance.
Warning:
Never immerse the appliance, power cord or plug in water or other liquids.
Do not use plastic or metal scrapers, harsh cleaners, chemicals, petrol, solvents or
other similar substances to clean any parts of the appliance. The surface nish could
be seriously damaged.
Regular cleaning
Use a soft sponge, slightly moistened in lukewarm water with a little detergent. Wipe
with dry dish towel.
Grease lter
The grease lter has to be cleaned at least once a month. The grease lter captures
grease, smoke and dust. It has a direct effect on the performance of the hood.
Warning:
There is a risk of re if the grease lter is not cleaned regularly.