Instruction Manual

EN
EN - 11
Switching On/Off
After connecting the hood to the electrical socket, all buttons and indicator lights will
light up briey and then go out. The on/off button and the display will light up white.
Press and hold the on/off button to turn on the hood. All indicator lights will light up
briey and the display will show "0". The cooker hood switches to standby mode.
If you are not going to use the hood, press the on/off button and the hood will turn off.
Note:
In standby mode, the hood automatically switches off after 2 minutes of
inactivity.
Power setting
While the hood is on, adjust its power using the
/ buttons on the control pan-
el of the hood or using the +/- buttons on remote controll.
You can set the power from 1 to 3, where 1 represents the lowest power and 3 the high-
est power.
If the display shows "0", the cooker hood stops and switches to standby mode.
Timer
1. When the hood is on, press the
button for 3 seconds.
2. The display ashes and you can set the time of automatic switch‑off time from 1 to
9 minutes, using the
/ buttons on the control panel of the hood or or +/-
buttons on remote control.
3. Press again the
button to save the setting. If you do not take any action within
10 seconds, the settings will be saved automatically.
4. When the cooker hood motor is on and the timer is set, it can be adjusted as
described above (steps 1 to 3). The display shows the countdown of the set timer
time.
5. If you want to set the timer while the hood is off, follow the instructions above
(steps 1 to 3). However, the countdown will only start when you turn on the hood.
Turn lighting on/off
Press briey the
button on the control panel or on remote control and the light-
ing turns on. Press the button again to turn the lighting off.
Remote control
The remote control is supplied with inserted batteries from the manufacturer. To use
the remote control, remove the protective lm from the battery compartment. It pro-
tects the battery from discharge and damage during transport.
If you want to use the remote control, point it at the sensor on the control panel. The
maximum range of signal sent from the remote control is 6 m. If obstacles are located
between the remote control and the appliance, the signal cannot be transmitted.
If the inserted battery is empty it needs to be replaced by the same type. Proceed as
follows: