User manual

2.4.1 USB Interface
Enduracut can connect to your computers USB port using a Keyspan Highspeed USB Serial Adaptor.
Caution!!
• DO NOT plug USB cable into Enduracut Cutter. That port is for loading firmware at the factory
only.
2.4.2 RS-232 Interface
. Connecting to the RS-232 (Serial) Port
1 For IBM PC, PS/2 users or compatibles, connect the RS-232C cable to the serial connector of the
assigned serial port (COM1 or COM2) of your host computer.
2 Set up the communication parameters (Baud Rate and Data Bits/Parity) to match the setting of
software package, refer to chapter 3 – “Misc” key description.