User guide

• www.signwarehouse.com SignWarehouse, Inc. 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834
30: Cleaning and Flushing the Print head: Cont’d
Draw some cleaning fluid
into the syringe (Fig1).
Then fasten the end of
the hose over the nipple
of the channel you wish
to unclog (Fig 2). Do not
be concerned if a small
amount spills inside the
print head carriage.
Gently depress the
plunger and force fluid
through the head. You
should see drops of
ink, followed by a fine
stream of clear fluid
coming from the bottom
of the print head (Fig 3).
Repeat this process for
each clogged channel.
When finished, wipe
away any excess fluid
around the head taking
care not to damage the
nipples. Reinstall the ink
cartridge and wipe up
any ink or fluid that has
seeped onto the platen
under the print head.
Then move the head
back over the platen and
reinstall the maintenance
station assembly.
Run three to five cleaning
cycles to purge the head
of cleaning fluid. Then
print a nozzle check.
30.3
30.4
If the head is clogged, the initial flow
of fluid will not be clear. Continue
until clear fluid is seen coming from
the head.
Fig 3
Fig 2
Fig 1