User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
24: Queue Properties: Cont’d
Printer Status: As Noted
in section --- you can
perform head cleaning
from the Printer Status
window instead of using
the Ink button on the
printer’s control panel.
You can also schedule
regular cleaning cycles
in the Printer Status
window by entering the
desired interval between
cleanings to the right of
the Head Clean check
box. Enter the time in
Hours and minutes. Once
set, the Printer Status
window will display the
time to the next
scheduled cleaning cycle
beneath the Head Clean
check box.
24.6
24.7
If you schedule automatic cleaning cycles, remember the printer must be turned on
and connected to the PC and the JetCUT software must be active in order for the
cleaning cycle command to be sent to the printer and executed.
Caution: If you decide to leave the printer on for long periods of time in order to
support automatic periodic head cleaning, it is recommended that you turn the
heater setting down below 120°F and/or eject the print media when the printer is
idle. This will prevent overheating the media and causing bucking and potential
head strikes.
The EnduraINK DTx aquaresin ink used in the DTx has viscosity characteristics that
prevent head clogs so that scheduling automatic cleaning cycles is not necessary. It
is more practical and economical to only perform head cleaning as needed to open
clogged nozzled.