User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
20: Print Cost Estimator: Cont’d
Now enter ink and
material cost values in the
Costing Window. This is the
raw data from which JetCUT
will compute your print costs.
The only values you need to
enter are material cost (per
square foot), Black ink and
Colored Ink cost (per liter).
The standard cost per liter for
EnduraINK DTx ink is $599.67
*. The square foot cost for the
20.4
20.5
Now, in the Costing Op-
tions tab in the bottom
of the costing window,
Click to add a check
mark next to “Record
Cost Data”. Then, in the
window to the right, you
will tell JetCUT where to
export the data. Click the
“Both” radio button.
Then click the ellipse
next to the Location for
Cost Data window to tell
JetCUT where to send the
date. A search window
will pop up allowing you to browse to a location where you would like to store the
data. The data will be exported to this location in a spreadsheet.
Now you are ready to add and process a print job and see the ink and material cost.
* Based on use of 150 ml refill bottles. The per liter cost of the disposable 17ml cartridges is $2,938 .24.
media of your choice can be found in your SignWarehouse catalog. Most rolls of
media for the PrismJET DTx are 13” x 30’ which is 32.5 square feet. Divide the roll
cost by 32.5 to obtain the material cost/square foot.