User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
Hold the Test Button for a
few seconds to perform the test
cut. en use a weeding tool to
remove the triangle. It should
be easy to li. e underlying
release liner should be lightly
scored, but not cut. Press enter
to continue.
e job is now waiting to be
sent to the cutter. Right-click on
the job and, from the drop down
menu, click Cut. JetCut will
prompt you to position the blade
over the registration mark. If
you’ve already done so, click OK
to send the job to the cutter.
Using the arrow keys, posi-
tion the blade in the center of the
square dened by the lower right
registration mark. Press the Ori-
gin button to set this as the new
origin point. e LCD display
will indicate that a new origin
point is set.
JetCUT will activate the
Cra ROBO Pro’s ARMS system.
e cutter will automatically nd
all four registration marks, then
immediately cut along the path
you created in JetPRO. e result
is a ready to use contour-cut de-
cal. Just peel and stick.
21
23
22
24
PrismJET DTx Print & Cut Workflow: JetPRO Cont’d
16.