User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
JetCUT uses print modes
to manage output qual-
ity. In order to get the
best results, you will
need to change this from
time to time depend-
ing on what media you
use. In the job listing on
the left, job information
is displayed, including
the Print Mode. In most
cases, it will be set to
Default.
12: First Print: Cont’d
12.10
The Print Mode should
be set to match the me-
dia being used whenever
possible. To change the
Print Mode, right-click on
the job, and select Prop-
erties.
Within the General Set-
tings, change the Print
Mode from Default to
whatever material type
you have loaded. Click
the down arrow and
select your material type
from the list. Click Ok.