User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
There are two ways to run a normal head cleaning. A normal head cleaning pumps
small amounts of ink through the head to flush the nozzles. As noted in section 10,
most clogs can be cleared with one to five cleaning cycles. Cleaning cycles can be
performed through the JetCut RIP software or via the printer’s control panel.
11: Head Cleaning: Clogged Nozzles
11.1
Control Panel: To start a
cleaning cycle from the
printer control panel,
wait until the printer is in
Ready status, then press
and hold the Ink button
for three seconds.
JetCUT: To start a
cleaning cycle from the
RIP, open any JetCUT
Queue and click Queue/
Properties.
From the Queue
Properties window, click
Printer Status. Then click
the box next to “Head
Clean”. A check mark will
appear and you will have
to option to
schedule regular head
cleaning cycles or to
perform one immedi-
ately. Click on Perform
Now to start the cleaning
cycle. Click the Perform
Now button again to
repeat the process if
needed. Click Cancel to
close the window and
resume printing.
11.2
11.3