User guide

• www.signwarehouse.com SignWarehouse, Inc. 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: 1-800-899-5655 •Local Phone: 903-462-7700 •Fax: 1-800-966-6834
6: Refilling Ink Cartridges - “Bulk Ink” System: Cont’d
Place the chip of the ink cartridge
into the chip reset tool, making
sure the prongs of the reset tool
are pressing against the chip. The
light indicator of the reset tool
will flash green and red. When
the light turns solid green, then
the chip is reset, and the cartridge
is ready to be loaded into the
print head again.
Note: Do not reinsert the refilled
cartridge until the print head is in
the Ink fill position. Press the Ink
button on the control panel to
move the head to the ink loading
6.5
6.6
position. If you insert the refilled cartridge in the printer without moving the head
to the ink load position the cartridge will not be reset, and the ink out light will
remain lit.
Then, insert the refilled and reset ink cartridge straight down into the print head.
Be careful to use even pressure on the front and the back of the cartridge, so that
you do not accidently damage the cartridge seal as you reinsert it. The chip on the
cartridge will fit snuggly against the prongs of the print head. The cartridge clip
will lock into place when the cartridge is inserted completely and correctly.