User guide

• www.signwarehouse.com • SignWarehouse, Inc. • 2614 Texoma Drive, Denison, TX 75020
•Toll Free Phone: [phone] •Local Phone: [phone] •Fax: [phone]
3: Production Queue Setup, cont’d.
After drivers are installed,
within the Printer
Defaults, set the port to
“generic ESC driver” port,
and set the Print Mode to
“Default”. (See Section 4
for Ethernet setup
instructions).
Make sure the “Continue
without Setting up”
Printer box is NOT
Checked. You will check
this box only if you are
creating a Cut Only
Queue for production of
vinyl decals. Click Next.
3.4
On the Cutter Defaults
screen,
1) Install your vinyl cutter.
For the Graphtec Craft
ROBO PRO, select the
Craft PROBO PRO HP-GL
driver. For the EnduraCUT
LX, select the Expert 24
LX. After it installs,
2) Set it as your cutter.
3) Select the appropriate
USB port and click Next.
NOTE: If you have a Print-
er Only (& no cutter to
set up) check the box to
Continue without setting
up a cutter.
3.5