User manual

User Manual
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: [phone] or toll free 800-899-5655 • Fax: [phone]
26
3.4 Menu Items Cont’d
Menu or Key Function Setting Default
[SPEED]
Speed To set or modify horizontal speed of the tool carriage . 3~60cm/sec; 3cm/sec
per step
51cm/
sec
Up Speed To set or modify vertical speed of the tool carriage. 3~60cm/sec; 3cm/sec
per step
51cm/
sec
Single To measure media width and length. Maximum Tracking 10
meters
Cutting Quality To set or modify cutting quality.
[Slower speeds / higher quality - Faster speeds / lower quality]
e Set Cutting Quality Page allows you to adjust and balance
vector mode’s quality and speed settings based on your specic
job. Dra Mode oers the highest output speed, sacricing quality.
Quality Mode oers the highest quality, sacricing output speed.
Keep in mind that speed and quality are usually a tradeo.
Dra, Norma l, Fair, Fine
Normal
[ CUT TEST ]
Square Cut To perform a cutting test at present blade position.
For more information, please refer to “4.3 Adjusting the Cutting
Force and Oset” to adjust blade force and cutting speed.
Redo Last Plot Recut:
To repeat the last job without re-sending the data.
1~99;
1 per step
Copy:
To copy the last job without re-sending the data.
* 1mm gap will be auto-generated between 2 copies).
* If the media length is not enough to continue, it will show
the LCM will display the message below:
O pOtu Sf a ;c e #
iCfo po e is f n hi s e d
If both functions are enabled at the same time, the cutter will per-
form the last setting only
1~99;
1 per step
Pattern Setting To provide two patterns for cut test
Note: It is recommended to select “Cross” if you are working on
thick pieces of materials.
“Arrow” and “Cross”
patterns
“A r r o w ”
Ratio Setting To adjust the size of the pattern 100%, 200%, 300%,
400%
100%
Continued Next Page...