Specifications

RDI DRIVERS FOR THIRD PARTY ARM DEBUGGERS
WITH JTAGJET
3
FIGURE 3 Confirming the driver location.
3. Connect the emulator JTAG cable to the JTAG connector on your ARM
system or evaluation board. Use either the 20-pin or the 14-pin JTAG
connector, depending on your target board. For examples of connecting
the emulator with selected target boards, see the ARM Board Setup User
Guide. Turn the emulator on first, and then turn on your target board.
Finally, configure your debugger, as described in section Configuring the
Debugger below.
Configuring the Debugger
With the ARM RDI driver for Signum emulators installed, you are ready to
configure your Debugger. The configuration process varies from debugger to
debugger. In the next several sections, you will find configuration details for
several popular debuggers: