Specifications

RDI DRIVERS FOR THIRD PARTY ARM DEBUGGERS

WITH JTAGJET

For the XScale processor, set the JTAG Header field to the following:

ARM,TRST:1.

FIGURE 27 An example of selecting the emulation mode for Texas Instruments ARM925-based

devices, such as OMAP1510, OMAP5910, OMAP710, OMAP310, or OMAP331.

3. Click the Board tab and select the endianness of your target board

(Figure 28).

In the File field, enter the name of the startup macro file. If you are using a

popular EVM board, chances are that an appropriate macro has been

provided for you. Otherwise, you may need to write your own one or leave

the field blank. For more information on board startup files refer to the

section Board Startup Macro File on page 28.

The Debug Handler Address field and the Vector Changes in Runtime field

apply to the XScale processor only. It may be necessary to increase the Sleep

After CPU Reset value if the XScale processor cannot be halted.

Select the Flash Write Enable option to load the code to flash memory

using the flash programmer built into the RDI driver. For more

information on flash programming, refer to the section Flash

Programming on page 30.