Specifications

SIGNUM SYSTEMS
22
The debugger attempts to connect to the emulator. If the JTAGjet has not
yet been configured, the RDI Configuration dialog appears. Proceed to
section Configuring the Connection on p. 22.
Configuring the Connection
1. In the Configuration dialog that appears, make sure that the Connection
tab is selected.
FIGURE 24 Configuring the emulator: the Connection tab.
• To establish a debugger-emulator connection with minimum effort,
press the Connect Automatically button. The connection parameters
appear in the Status box.
• For added control over the connection, press the Specify Connection
button to set up the communication port and its parameters
manually.
2. Once the connection has been established, select the JTAG tab in the
JTAG configuration dialog. Choose your target device from the CPU
drop-down list as follows.