Specifications

SIGNUM SYSTEMS
10
2. Proceed to section Configuring
the Connection on p. 22, keeping
in mind that semihosting should
be turned off (see Figure 28
later in the text). Whenever you
load an application program to
the target board from within
eBinder, the Signum RDI
driver’s configuration dialog box appears, allowing you to modify the
driver settings as needed (Figure 24).
GNU gdb Debugger
The GNU gdb debugger connects to the emulator through Signum GDB Server.
The server must run on an MS Windows computer, whereas the debugger can
run on a local computer (the same as the PC on which the server executes) or on
a remote computer under either Linux/UNIX or DOS/Windows operating
system.
! To connect the gdb debugger to the emulator via the GDB Server:
1. Execute the GDBserver.bat file found in the RDI driver folder to start
the server. You may want to modify the --remote-port parameter in
GDBserver.bat order to select the desired communication port. Note
that when running the server for the first time, it is necessary to use the –
config-dialog option that invokes the JTAGjet configuration dialog box.
Once configured, the server can be run without the --config-dialog
option. Proceed to section Configuring the Connection on p. 22 to set up the
connection parameters, and then complete this procedure.
Note: To set a system variable on a
Windows XP system, click Start |
Control Panel | Systems | Advanced
| Environment Variables. For
information about other systems,
please refer to the documentation of
the specific OS.