Operating instructions

ak 3.11
23
BXT 2 BXT 2-19
12. Error Code List
12.1. User Errors
Faults in operating sequence “User errors” are no indication of a tool related defect (except defective
switch). The tool calls the users attention to faulty operation.
During Tensioning:
Nr. Fault in operating sequence System reaction Error message Rectification
A11
Tension with rocker lever pulled
Tensioning is not executed
Beep sound
Release rocker lever
A12
Rocker lever is pulled during
tensioning
Tensioning is
interrupted
None Tensioning again
A13
In Automode:
Rocker lever, tensioning
button or welding button is
activated during tensioning
Tensioning is
interrupted
None Start process again
A14
Tension button is pressed to many
times
Tensioning is no longer
executed
Beep sound
Execute welding or pull
rocker lever
A15
Tension time out.
Adjusted tension force could not
be reached
Tensioning is
interrupted
„E“blinking,
intermittent beep for
5s
Start process again
A16
Tensioning with cam switch activated
Tensioning is not executed Beep sound Pull rocker lever
Welding:
Nr.
Fault in operating sequence
System reaction
Error message
Rectification
A20 Try to weld without tensioning first Welding is not executed
Beep sound
Press tension button
before welding
A21
Try to weld with rocker lever pulled
Welding is not executed
Beep sound
Release rocker lever
A22 Interrupted welding process by pulling
rocker lever
Welding process is completed
but the seal is invalid.
„E“blinking,
Intermittent beep for 5s
Repeat the strapping,
Seal is not correct
A23
Interrupted cooling by pulling rocker
lever
Cooling is interrupted
E“blinking,
Intermittent beep for 5s
Repeat the strapping,
Seal is not correct
A24 Welding time out
cam position could not be detected
(Micro switch Pos. 103)
Welding is interrupted
„E“blinking,
Intermittent beep for 5s
Repeat the strapping,
Seal is not correct
Failure Codes A22 and A23 are counted by the system. The number of failures is displayed when the
data-cable is used (chapter 5.3)
Error message „empty battery“:
The error code „empty battery“ depends on the mode which is currently in use.
Nr. Battery empty
System reaction
During welding/tensioning
(Motor end phase
switches off)
1.
welding/tensioning process is interrupted
2.
Error code E23 is displayed (see chapter
12.4
)
Into Run Mode
(within 30s)
1. 4 beep sounds and segment display is blinking
2. Tool switches off
Into Idle Mode
(within 5min)
1. 4 beep sounds and segment display is blinking
2. Tool switches off
Into Sleep Mode (more than 5
min after last usage)
1. Tool switches off