Operating instructions

4
07.09
SIGNODE BXT2
TABLE OF CONTENTS
Page
SHORT INSTRUCTIONS 2
1 Technical data 4
2 General information 8
2.1 Information on environmental protection 8
3 Safety instructions 10
4 Description 12
4.1 Construction 12
4.2 Operating panel 12
4.3 Function 12
5 Operating instructions 14
5.1 Charging the battery 14
5.2 Operating the tool 14
5.3 Checking the seal 18
5.4 Checking battery charge 18
5.5 Setting mode of operation 18
5.6 Setting strap tension 20
5.7 Setting soft tension 20
5.8 Setting welding time 20
5.9 Setting strap width 20
6 Special functions 22
6.1 Switch touch-pad lock on and off 22
6.2 Sleep mode 22
6.3 Tool reset 22
7 Preventive and corrective maintenance 24
7.1 Cleaning/replacing tension wheel 24
7.2 Cleaning/replacing tooth plate 24
7.3 Replacing knife 24
7.4 Trouble shooting 26
8 Wear parts / Recommended spare parts 28
8.1 Parts list 28
Exploded drawing 32
DECLARATION OF CONFORMITY
www.signode.com
We take sole responsibility for declaring that the tool
BXT2 to which this declaration refers is in full conformi-
ty with the current requirements of the guidelines laid
down by the council on 22th June 1998 (98/37/ECC),
“Machine Guidelines“.
Furthermore, electrical installations are in conformity
with the guideline laid down by the council on 12.
December 2006 (2006/95/EEC) “Low Voltage Guide-
lines“ and 15. December 2004 (2004/108/EEC)
“EMV Guidelines“.
Harmonised standards applied:
EN ISO 12100-1, EN ISO 12100-2, EN 349,
EN 1050, EN 61000-6-1, EN 61000-6-3
15.11.2008
General Manager General Manager Prod.
Packaging Technology: Packaging Technology:
U. Schweizer M. Binder
SIGNODE ENGINEERED PRODUCTS
Hand Tool Division
3610 W. Lake Avenue,
Glenview, Illonois 60025