Instruction Manual

CAUTION:
This fixture is designed for permanent installation in ordinary (Non-Hazardous) locations in accordance with the National Electrical Code and
all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and fixture operate at high temperatures.
Contact with combustible materials can cause fire and personal contact can cause severe burns.
FLUXSTREAM LED STRIP
Page 2 of 4
INSTALLATION INSTRUCTIONS
CAUTION: THE INSTALLATION AND SERVICING OF
THIS PRODUCT SHOULD BE PERFORMED BY A
QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
CONNECTING LUMINAIRES FOR ROW MOUNTING
1) Make sure each luminaire is secured to building structure, by at least two points, before process begins, do not use "endcap to
endcap" connection for replacing cable, pendant or surface mounting options.
2) Remove joining end caps and remove KOs. Secure the endcaps together with customer supplied (2) #8 screws and (1) 1/2" chase
nipple to create joiner as shown in FIG 6A.
IF USING FSSJ- COUPLER ACCESSORY (SHOWN IN FIG 6B): Remove and dispose of joining endcaps.
3) Slide joiner assembly or FSSJ coupler accessory into fixture. Slide in next luminaire into joiner assembly as shown in FIG 7A or
FIG 7B for FSSJ accessory.
FIG 6A: JOINER ASSY
FIG 7A: ENDCAP JOINER ASSY
FIG 8: ROW MOUNT CONFIGURATION
To remove lens from housing, push side of lens until the opposite side of lens protrudes from housing. Then pull protruding lens
downward until removed as shown in Figure 5. This should be applied down the length of the fixture. Squeezing both sides of the
housing inward while pushing side of lens will help remove lens and LED board carrier. Once LED board carrier is removed from
housing, the lens will need to be removed from LED board carrier by sliding it down the length of the LED board carrier.
FOR FIXTURE MAINTENANCE (ACCESSING WIRING COMPARTMENT)
FIGURE 5: REMOVING LENS
FIG 6B: FSSJ ACC.
(Purchased Separately)
4) Install screws as shown in FIG 8 and make electrical
conncetions inside luminaire in accordance with the National
Code and local regulations. Refer to page 1 for installing the
LED carrier and lens.
FIG 7B: FSSJ ASSY
12NC: 44210
201
(ENGLISH)