User Guide

ManualsBrandssignify ManualsEmergencysignify Chloride Exit/Emergency Compac CLU2, CLU3

Codes and standards

• NFPA 70

(National Electric Code)

• NFPA 101

(Life Safety Code)

• ETL listed to Standard 924

• UL Listed for damp locations

Construction

• Wall or ceiling mounted

• UL 94 V-0.5VA Flame rated, UV

stable thermoplastic housing

• Provisions for surface

mounted conduit to top of

wall mounted unit

• Back plate keyhole slots are

easily removable knockouts

for securing to single gang

boxes, 3" J-boxes and

4" J-boxes

Installation

• Designed for wall or ceiling

mount with a universal J-box

pattern on back plate

• Surface conduit entry on top of

housing in center of backplate

• CLUx unit mounts single gang

boxes, 3" J-boxes and 4"

J-boxes

Electronics

• 120/277VAC, 50-60Hz dual

voltage selectable input

• Surge protected, solid state

circuitry

• Charging systems are complete

with low voltage disconnect

(prevents deep discharge

of battery), battery lockout

(prevents discharge of battery

during installation), and

brownout protection

Power consumption

• CLU2 120V = 0.036 / 277V = 0.030

• CLU3 120V = 0.055 / 277V = 0.040

Lamps

• CLU2 unit contains two - 2.2W

adjustable LED lamp heads

longlife LED lamp source head

(5000K)

• CLU3 unit contains three - 2.2W

LED lamp heads longlife LED

lamp source head (5000K)

(two adjustable, one fixed)

Battery

• Maintenance-free sealed 7.2v

Nickel Metal Hydride battery

• Manual test switch and LED

light indicator

• Supplies emergency illumination

for a minimum of 90 minutes

• Batteries have an approximated

service life of 6 to 8 years at a

operating temperature range of

10°C to 40°C (50°F to 104°F)

Remote capability

• CLU2 emergency unit provides

enough remote capability to

supply DC power to 2 (CLR1W)

LED remote lamps heads or

1 (CLR2W) dual LED remote

lamp head.

• CLU3 provides enough remote

capability to feed one CLR1W

LED remote lamp head.

Listings

• California Energy Commission,

Title 20 compliant (Battery

Charger)

Warranty

• Five year full warranty on unit.

Self-diagnostics/Self-test

The CLU2/3 units contain self-

diagnostic/self-test electronics

as a standard feature. An

automatic self-test is performed

every month for 3 minutes, and

a 30 minute self-test every six

months. A manual test may also be

performed at anytime by pressing

the manual test button.

Manual testing:

Tes t button Length of test

1 press 30 seconds

2 presses 3 minutes

3 presses 30 minutes

4 presses 90 minutes

Self-Diagnostic Red status indicator:

Indicator Status

One blink Battery is not

connected

Two blink s Battery voltage

has dropped below

acceptable value

Three blinks Charger board

circuit fault

Four blinks Transfer fault

Five blinks Lamp fault

Six blinks Remote lamp

head fault

Seven blinks EXIT Led strip fault

The Self-diagnostic/self-

test electronics meets the

requirements of the National

Electric Code and/or the National

Fire Protection Association.

CLU2/CLU3 Compac emergency unit

The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract.

is subject to change, without notice. Signify does not give any representation

or warranty as to the accuracy or completeness of the information included

herein and shall not be liable for any action in reliance thereon. The information

presentedin this document is not intended as any commercial offer and does

notform part of any quotation or contract, unless otherwise agreed by Signify.

Compac_emerg_CLU2_3 02/21 page 3 of 3

Signify North America Corporation

200 Franklin Square Drive,

Somerset, NJ 08873

Telephone 855-486-2216

Signify Canada Ltd.

281 Hillmount Road,

Markham, ON, Canada L6C 2S3

Telephone 800-668-9008

All trademarks are owned by Signify Holding or their respective owners.