Specifications

ManualsBrandsSignify Investment ManualsElectronicsDigital Device

Signify Classified - Internal#

Hue Engine 9290024695

Specification item Value Unit Condition

Description

Hue Engine is second generation of a general purpose Zigbee& BLE

certified building block for Hue connected lighting applications

e.g. Hue White, Hue White Ambiance and Hue White and Color

ambiance for lamps and luminaires.

Logistical data

12NC 929002469501

Minimum Order Quantity 500 PCE

Electrical input data

Vcc voltage 3.0~3.6 Volt Ripple<50 mV

Current (normal) 18 mA

Electrical output data

Average power consumption 60mW Watt

Standby power <100mW

Wiring & Connections

I/O definition

Ground 1 GND

ADC2, e.g. for voltage sensing General purpose in/out 2

2 ADC2

ADC1, e.g. for current sensing

3 ADC1

to be used as ADC (e.g. NTC read-out), I2C, SPI or PWM 4 Mixed_out_1

to be used as ADC, I2C, SPI or PWM PWM_CHN1

5 Mixed_out_2

General purpose in/out 1: E.g. for button control

6 GPIO1

General purpose in/out 2: E.g. for button controlPWM_CHN3

7 GPIO2

i.e. for current source

8 Enable

PWM output 9 PWM_CH0

PWM output 10 PWM_CH1

PWM output 11 PWM_CH2

PWM output 12 PWM_CH3

PWM output 13 PWM_CH4

Ground 14 GND

3V power in 15 VDD

Used for SW programming, UART bus communication 16 TXD

Used for SW programming, UART bus communication 17 RXD

Used for SW debugging 18 Nreset

Used for SW debugging 19 SWCLK

Used for SW debugging

20 SWDIO

Features & Functions

Hue White Color Ambience yes

Hue White Ambiance yes

Hue White yes

Dimming yes

Device diversity yes by late state configuration

Automatic color consistency yes

OTA upgrade yes

Over the air upgradable when connected to the Hue Bridge

Wireless specifications

Wireless RF mode frequency band 2400–2483.5 MHz MHz

Wireless communications protocol

IEEE 802.15.4

Bluetooth LE

ZigBee protocol

Bluetooth LE protocol

Operating channel

Zigbee 11 – 26

Bluetooth 0-39 channels

Range 12 meter

indoor

Frequency tolerances (Typical) +/-40 ppm

Continuous single tone

Output power (Typical) 9 dBM

Measured at antenna feedpoint

EVM (Typical) 18 %rms

Receiver Sensitivity (Typical) -102 dBM

conducted sensitivity

TRP 6 dBM

when mounted on a motherboard of 30x40mm (i.e. Hue Connect)

LED board requirements

Hue White Color Ambience Unified Gamut

covered by L1.5 specifications

Tunable white CCT range: 2000-6500K

Summary of content (5 pages)

PAGE 1
Signify Classified - Internal # Hue Engine 9290024695 Specification item Value Unit Condition Hue Engine is second generation of a general purpose Zigbee& BLE certified building block for Hue connected lighting applications e.g. Hue White, Hue White Ambiance and Hue White and Color ambiance for lamps and luminaires. Description Logistical data 12NC Minimum Order Quantity 929002469501 500 PCE 3.0~3.
PAGE 2
Signify Classified - Internal # covered by L1.5 specifications Hue White Ambiance Tunable white CCT range: 2000-6500K covered by L1.5 specifications Hue White 2700K / 3000K / 4000K covered by L1.5 specifications Insulations Dimensions & Weight Length Width Height Fixing hole diameter Fixing hole distance Weight 23.5 18 3.
PAGE 3
Signify Classified - Internal FCC # FCC Labelling Requirements When integrating HUE Engine into a product it must be ensured that the FCC labelling requirements are met. This includes a clearly visible label on the outside of the finished product specifying the FCC identifier (FCC ID: 2AGBW9290024695X). This exterior label can use wording such as “Contains Transmitter Module FCC ID: 2AGBW9290024695X” although any similar wording that expresses the same meaning may be used.
PAGE 4
Signify Classified - Internal # IC (ISED Canada) Approvals This device complies with ISED Canadalicense-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
PAGE 5
Signify Classified - Internal # Les exigences d’étiquetage pour Industrie Canada sont semblables à celles de la FCC. Encore une fois un clairement visiblement étiquette doit être placée à l’extérieur du produit fini indiquant quelque chose comme "Module émetteur de Contains, IC ID: 20812-24695X", bien que tout même libellé qui exprime que le même sens peuvent être utilisé.