User's Manual

SMART RF MODULE GEN II
Signify Classified - Internal
unintentional radiator, the transmitter shall be placed in the receive mode or idle mode, if possible. If
receive mode only is not possible then, the radio shall be passive (preferred) and/or active scanning. In
these cases, this would need to enable activity on the communication BUS (i.e., PCIe, SDIO, USB) to
ensure the unintentional radiator circuitry is enabled. Testing laboratories may need to add attenuation
or filters depending on the signal strength of any active beacons (if applicable) from the enabled
radio(s). See ANSI C63.4, ANSI C63.10 and ANSI C63.26 for further general testing details. The product
under test is set into a non-signal mode with a partnering device/equipment, as per the normal
intended use of the product. To ease testing, the product under test is set to transmit at a high duty
cycle, such as by sending a file or streaming some media content.