User's Manual

SMART RF MODULE GEN II
Signify Classified - Internal
o [TH,RfTest,init,0] //RF test initialize
o [TH,RfTest,setmode,unmodtx] // setting CW mode
o [TH,RfTest,setmode,txstream] //setting modulated wave mode
o [TH,RfTest,setchnl,18] //set channel 18
o [TH,RfTest,setpwr,4] //set RF power 4dBm
o [TH,RfTest,start,0] //start to transmit
• For BLE TX, similar function can be activated by using HueApprobationTool.exe attached
BLE test FW.rar
Zigbee Test FW.rar
HueApprobationTool.
rar
6.9 Additional testing, Part 15 subpart B disclaimer
The final host / module combination needs to be evaluated against the FCC Part 15B criteria for
unintentional radiators in order to be properly authorized for operation as a Part 15 digital devices. The
host integrator installing this module into their product must ensure that the final composite product
complies with the FCC requirements by a technical assessment or evaluation to the FCC rules, including
the transmitter operation and should refer to guidance in KDB 996369. Frequency spectrum to be
investigated For host products with certified modular transmitter, the frequency range of investigation
of the composite system is specified by rule in Sections 15.33(a)(1) through (a)(3), or the range
applicable to the digital device, as shown in Section 15.33(b)(1), whichever is the higher frequency range
of investigation. Operating the host product When testing the host product, all the transmitters must be
operating. The transmitters can be enabled by using publicly available drivers and turned on, so the
transmitters are active. In certain conditions it might be appropriate to use a technology-specific call box
(test set) where accessory devices or drivers are not available. When testing for emissions from the