User`s manual

5
Setup
5. Remove the cover piece on the
side of the tester.
6. Put the scanner assembly back
into the tester. Make sure the
Add-On connector sticks out the
side of the tester.
7. Connect the Add-On connectors.
Make sure the connectors are
fully connected.
8. Push the cable and connectors
into the main unit.
To remove the plastic rivets
holding the cover piece,
use a
screwdriver or any hard flat object
to push in the rivet plunger, then
remove the plunger.
Cover Piece
Add-On Connector
Scanner Assembly
Scanner Add-On