User`s manual

2
Setup
Set Up the Tester
1. Connect the power supply and
power cord together. Then plug
the tester into a grounded power
outlet.
2. Connect the probe to the tester.
3. Turn on the tester and make sure
it displays the main screen.
If you are connecting either a
printer or Scanner Add-ons,
see the applicable section
that follows. Otherwise skip
to Tester Basics on page 7.
These digits could be different, but
otherwise the main screen should
look similar to this.
S
I
G
NATURE
1100
R+
Set User Preferences
Set Up Test Program
TEST: 1B4137-4Z020
Probe
Well grounded
power is essential
for the tester to
operate accurately
Power
Supply
Power
Cord