User`s manual

32
Component
Setting & Test
To Edit Test Parameter Settings:
You can only edit the Test Parameter Settings
of the loaded test program.
1. Make sure the test program you want to
edit is loaded.
You load a new test program by learning a
cable or retrieving the test from a memory
location.
2. From the main menu, press Set Up Test
Program.
3. Press Edit to edit the loaded test.
4. Select from the category of Test Settings
you want to edit.
5. Select the specific Test Setting you want
to edit.
6. Set the desired value for the Test
Parameter Setting. When selected, some
Test Parameter Settings toggle between
two values. Others scroll to the desired
value.
7. Press ACCEPT or back to exit the
specific Test Setting.
8. Press back to exit the category of Test
Settings
9. Press back to exit the edit menu.
If you made changes, a screen briefly
confirms the changes in the loaded test
program.
Remember if you’ve retrieved the test from
a memory location to be the loaded test,
the test in the memory location is not updated
until you save the loaded test back to its
memory location.
The Signature of
the loaded test is
displayed on the
main menu.