User`s manual

30
User
Preferences
Auto Test Results
The Auto Test Results user preference determines if the tester will print test results
automatically.

When Auto Test Results is ON, test results will print automatically after each cable is
tested, or after a test run when the operator presses STOP TEST RUN.

When Auto Test Results is OFF, the tester will print test results only when an operator
presses PRINT TEST SUMMARY.
If Auto Test Results is ON, you can choose one of three reports: (1) All Tests, 1 Line, (2) Good,
Full Page, or (3) Bad, Full Page. The reports Good, Full Page and Bad, Full Page print at the
end of a test run when the operator presses STOP TEST RUN or returns to the main screen.
The All Tests, 1 Line report prints the results of each test after the test completes.
Selections Factory Default
Digital Outputs
disable/enable pins
5, 6, 7, 8, 10, 11
pin 7 = Cable Counted Good
pin 8 = Cable Counted Bad
The Digital Outputs user preference determines how the tester controls the output pins on the
the digital I/O port. There are six digital outputs on the 1100R+ tester. The 1100R+ has six
outputs that can drive an external device according to various “events” in the tester. These
events occur as the tester powers up, learns a cable, tests a cable, and displays the test results.
Controlling an output line requires two triggering events. For more information see the Digital I/O
section on pages 49 to 54.
Selections Factory Default
ON or OFF OFF