User`s manual

16
Using the
Tester
Testing a Cable
To test a cable on the 1100R+ tester:
1. Make sure the test program for the
cable you’re testing is loaded.
You can load a different test program by:

Creating a test from a sample cable,
OR

Retrieving a test from memory.
2. Duplicate the adapter setup you had
in the original test.
To remember the correct adapter
positions in the tester:

Refer to the documentation you
created for the test.
OR

Press Test for the loaded test
program.

Press Show Required List.
1100R+ Cable Documentation
Cable Signature: 39E92F-4Z020
J1 Adapter Signature: F5B4E0
J2 Adapter Signature: 03FAC1
Connection Resistance: <Auto .5
Insulation Resistance: 50M
Ω
3. Attach the cable to be tested and
start the test.

If you haven’t already, press Test for
the loaded test program.

Attach the first cable to be tested.
If the User Preference Test Mode is
set to CONTINUOUS the test will
start automatically. If Test Mode is
set to SINGLE TEST, press START
TEST to start the test.
The loaded test
program is
always displayed
on the main
menu.
A
dapters set up in
original positions