User`s manual

8
Tester
Basics
Installing Adapters on the Tester
To Install Adapters:
1. Turn both fasteners on the
cover plate sideways.
2. Remove the cover plate from
the tester.
3. Slide in an adapter until it is
fully seated.
Note: To insert adapters side by
side, first insert the adapter on the
left side; then insert the adapter on
the right side.
turn
sideways
cover plate
When you insert a
small Single-High
Adapter as shown,
make sure the adapter
is against the edge of
the scanner as you
slide it. This will
insure the adapter
mates correctly.
Left Side
Right Side