Installation Guide

7628 Accessory Multiple Curve Bar V 1.0
Assembly Instructions:
Accessories are only to be used on the Stander pole (model numbers 7620 and 7621). It is advised to have assistance when installing
this product.
1. Identify all parts as shown in Figure 1 before discarding the product box.
FIGURE 1
2. Determine the desired height to install the Handle accessory as shown in Figure 2. NOTE: There are 2 diameter sizes of pole tubes.
This accessory is to be installed on the larger diameter pole tube (see Figure 2).
3. Secure the Metal Collars around the existing pole using 4 Large Screws and the Large Allen Wrench (IMPORTANT: Do not tighten
Large Screws until all screws have been installed).
FIGURE 2
4. Periodically check the accessory between uses and make sure that the Curved Handle accessory is secure to the pole and functions
properly. The Metal Collar assemblies should not rotate when the product is being used.
5. If the installer/user(s) have any questions or concerns, please call Stander Inc. at [phone] or [phone].