Specification Sheet
Table Of Contents
≥ 24"
(610 mm)
CUTOUT DIMENSIONS – FLUSH INSTALLATION
UC DRAWERS
TOP VIEW
INSTALLATION CLEARANCES – FLUSH INSTALLATION 3/4" CUSTOM PANEL DIMENSIONS – FLUSH INSTALLATION
SKSUD2402P
24-INCH BUILT-IN UNDERCOUNTER
DRAWER REFRIGERATOR
A minimum 4" (101 mm) finished return that matches the cabinet
exterior is recommended on all sides and at the top of the cutout
opening. The shaded area will be visible after installation.
*
Side clearance at cabinet
Side clearance at front panel
**
*
23 11/16"
(602 mm) with panel
23 7/16"
(595 mm)
23 11/16" (602 mm)
Upper drawer =
15 9/16"
(395 mm)
Lower drawer =
18 3/8"
(467 mm)
18"
(457 mm)
with panel
≥ 24" (610 mm)
5/16"
(7.5 mm)*
3/16"
(4 mm)**
3/16"
(4 mm)**
5/16"
min.
min.
(7.5 mm)*
23 11/16"
(602 mm)
15"
(381 mm)
≥ 24"
(610 mm)
≥ 34 1/2"
(876 mm)
30 5/16"
(770 mm)
4"
(101 mm)
≥ 24"
(610 mm)
CUTOUT DIMENSIONS – FLUSH INSTALLATION
UC DRAWERS
TOP VIEW
INSTALLATION CLEARANCES – FLUSH INSTALLATION 3/4" CUSTOM PANEL DIMENSIONS – FLUSH INSTALLATION
SKSUD2402P
24-INCH BUILT-IN UNDERCOUNTER
DRAWER REFRIGERATOR
A minimum 4" (101 mm) finished return that matches the cabinet
exterior is recommended on all sides and at the top of the cutout
opening. The shaded area will be visible after installation.
*
Side clearance at cabinet
Side clearance at front panel
**
*
23 11/16"
(602 mm) with panel
23 7/16"
(595 mm)
23 11/16" (602 mm)
Upper drawer =
15 9/16"
(395 mm)
Lower drawer =
18 3/8"
(467 mm)
18"
(457 mm)
with panel
≥ 24" (610 mm)
5/16"
(7.5 mm)*
3/16"
(4 mm)**
3/16"
(4 mm)**
5/16"
min.
min.
(7.5 mm)*
23 11/16"
(602 mm)
15"
(381 mm)
≥ 24"
(610 mm)
≥ 34 1/2"
(876 mm)
30 5/16"
(770 mm)
4"
(101 mm)
Refrigerator can be installed ush with 3/4" custom panel
or optional stainless steel panel kit.
With a 24" (610 mm) cutout depth, the front face of the
refrigerator ts ush with 24" (610 mm) depth adjacent
cabinets. Electrical must be installed in adjacent cabinet
for ush installation.
A 115V, 60Hz., 15 amp power supply is required. An
individual properly grounded branch circuit or circuit
breaker is recommended. Install a properly grounded
3-prong electrical receptacle recessed into the back wall
or adjacent cabinet.
Note: GFCI (ground fault circuit interrupter) is not
recommended.
Page 3 of 4 | Eective 1/22
SKSUD2402P