Installation

7
ENGLISH
Enclosure
• The panel above the appliance must be made from a solid material (not MDF) that is at
least 5/8" (16 mm) thick.
• The side walls of the cavity or enclosure must be ush.
• The front 4 inches (100 mm) of the interior surface (furniture return) will be visible when
doors are open. Make sure this area is nished to at least 4 inches deep.
• Follow the specications for the installation enclosure to ensure a trouble free installation.
• Above all, the enclosure cannot be out of square. Use a spirit level or measure the
diagonals of the opening to make sure corners are square.
• The appliance is attached at the sides and the top to either the enclosure or to adjacent
cabinets. Make sure the enclosure or the adjacent cabinets are securely connected to the
oor or wall structures.
Floor
WARNING
• The oor in the installation area must be rm, level, and rigid for safe installation and best
performance.
• Do not install the appliance on a platform or raised structure.
• The structure underneath the appliance must be able to support the weight of the
appliance without tilting or exing.
• For best performance and to avoid leakage, level the appliance.
Electrical Requirements
WARNING
Electrical Shock Hazard
✓ Plug into a grounded 3 prong outlet.
✓ Do not remove ground prong.
✓ Do not use an adapter.
✓ Do not use an extension cord.
Failure to follow these instructions can result in death, re, or electrical shock.
Follow all state and local codes or NEC.
The appliance comes with a UL listed 3 wire power supply cord.
The appliance requires a 3-wire receptacle.
The receptacle must be installed by a licensed electrician only.