Installation

Adjusting the Door Spring

Adjusting the Door Stop

Rotate the adjusting screw with the T20 bit

provided.

I = maximum spring tension

0 = no spring tension

Maximum spring tension is recommended.

(Optional) After adjusting the door spring,

attach the gray plastic sheets to hide the

adjusting screws.

Water Filter Bypass

Removing the water lter automatically puts the

appliance in the lter bypass mode. This allows the

appliance to be run without a water lter.

Removing the Water Filter

1. Push in slightly on the water lter access door to

open it.

2. Use the cap to rotate the water lter counterclockwise

and pull out the water lter. See the owner's manual

for detailed instructions.

Water filter

The default door stop position is 115°. Follow

these instructions to change the door stop

position to 90°.

1. Open the door to 90°.

2. Insert the door stop pin in the holes which are

now aligned at the back of the hinge. Use a

rubber mallet to fully insert the pin.