Installation guide

3DJH11
Have a third person raise up and hold the island range hood in position, connect power plug to the 12” hanging
electrical cord, and connect the duct work to the range hood.
Mount the hood to the lower support frame using four “D” bolts and four “E” nuts: Securely fasten two “E”
nuts to two “D” bolts by reaching up from the underside of the hood. Repeat this step to secure the other side
using two “E” nuts to two “D” bolts.
After all four “D” bolts and four “E” nuts securely fastened, connect the lower end of the duct tube to the hood
and slide the lower chimney cover down carefully so that it sits on top of the hood.
Install grease cup and aluminum filters then check the operation of the range hood.
9.
10.
11.
12.
Air Movement Direction
8SSHUVXSSRUWIUDPH
Support frame extensions
(Hole to hole distance: ≈
⅝
-inch)
Island mount
UDQJHKRRG
/RZHUVXSSRUWIUDPH
0RWRUKRXVLQJ
Electric circuit box
6” Round duct (exhaust)
Re-circulating kit exhaust
(Re-circulating kit not shown)
Duct work and electric
ZLULQJUHJLRQ
$
%
C
' E
)
Installation Overview
% C
Qty: 4 PCS
$
Qty: 32 PCS
%
Qty: 4 PCS
'
Qty: 32 PCS
C
Qty: 4 PCS
E
Qty: 4 PCS
(Optional with
UHFLUFXODWLQJ
kit. Pre-installed
when kit ordered
WRJHWKHUZLWK
range hood)
)
Hex Key
Qty: 1 PCS
(Optional with glass canopy)
Glass Canopy Screw
Qty: 4 PCS
(Optional with glass canopy)
Installation (Continued)
NOTE:
screws are designed for dry wall.
Not to be used with any other types
RIZDOOV
A distance of 28” to 31” is recom
mended* between stove top and the
bottom of range hood.
Always use first and second holes
on the support frame extensions to
VHFXUHORZHUVXSSRUWIUDPH
* Due to different ceiling height configu-
rations, recommended height may not be
applicable.



IMPORTANT: Minimum height = Longest chimney + 1½-inch
$