Installation guide
21Island Mount Range Hood Installation Instructions
exposure and wipe dry with a clean cloth.
Cleaning Aluminum Grease Filter/Stainless Steel Filterless Grill:
Drain oil from oil containers before oil and residue overow.
The metal lters tted by the factory are intended to lter out residue and grease from cooking. Filters may not need
to be replaced on a regular basis but are required to be kept clean.
Filters should be cleaned after every 30 hours of use.
Remove and clean by hand or dishwasher. Spray degreasing detergent and leave to soak if heavily soiled. Dry lters
and re-install before using hood.
Replacing Filters:
Should lters wear out due to age and prolonged use, please contact your local reseller for replacement lters. Also
replace damaged lters if there is punctured or broken mesh, or a bent or broken frame.
Replacing the light bulb:
This range hood uses halogen bulbs (please refer to the actual specication of the hood purchased):
20W 12V.
Product ID: SV168/198-ACS-HAL20W GU10 220V
Make sure the range hood is unplugged or turn OFF breaker.
Make sure the lights are cool to touch, turn the inner ring counter-clockwise with a small at head screw driver then
pop out the protective covering.
Install a new halogen light bulb and reverse the steps.
Turn ON breaker and range hood to test for operation.