Installation guide
19Island Mount Range Hood Installation Instructions
4. The lights work but the blower is not spinning at all, it is stuck or
it is rattling:
The blower might be jammed or scraping the bottom due
to shipping damages. Please contact Customer
Service immediately.
5. The hood is not venting out properly:
Make sure the distance between the stove top and the
bottom of the hood is within 28”-31” in distance.
Reduce the number of elbows and length of duct work. Check if all joints are properly connected,
sealed, and taped.
Make sure the power is on high speed for heavy cooking.
6. Purpose of the slots/holes/openings near the top of the upper chimney:
These slots/holes/openings are used to exhaust cleaned air with optional re-circulating kit. If you did not
install one, you do not need them.
For all other inquiries, please contact Customer Service.
USE AND CARE INFORMATION
Operations:
Read and understand all instructions and warnings in this manual before operating the appliance. Save these
instructions for future reference.
Always leave safety grills and lters in place. Without these components, operating blowers could catch on to
hair, ngers and loose clothing.
Never dispose cigarette ashes, ignitable substances, or any foreign objects into blowers.
Never leave cooking unattended. When frying, oil in the pan can easily overheat and catch re. The risk of self
combustion is higher when the oil has been used several times.
Never cook on “open” ames under the range hood. Check deep-fryers during use, superheated oil may be
ammable.
Cleaning:
The saturation of greasy residue in the blower and lters may cause increased inammability. Keep unit clean
and free of grease and residue build-up at all times to prevent possible res.
Filters must be cleaned periodically and free from accumulation of cooking residue (see “Cleaning Instruc-
tions”). Old and worn lters must be replaced immediately.
Do not operate blowers when lters are removed. Never disassemble parts to clean without proper instructions.
Disassembly is recommended to be performed by qualied personnel only. Read and understand all instruc-
tions and warnings in this manual before proceeding.