Installation guide
18Island Mount Range Hood Installation Instructions
RANGE HOOD OPERATIONS AND WIRING DIAGRAM (CONTINUED)
TROUBLESHOOTING
1. If the range hood or halogen light does not operate after installation:
Verify that the range hood has been plugged in, make sure that all power has been turned back ON, the
fuse has not blown and all electrical wiring is properly conected.
Swap out light assembly with working assembly to determine if it is caused by defective bulbs. See
“Replacing the light bulbs”.
2. The range hood vibrates when the blower is on:
The range hood might not have been secured properly to the ceiling or wall. Check with your installer.
3. The blower or fan seems weak:
Make sure that the duct sized used is at least 6” or 3 -1/4x10”. Range hood will not function efciently with
insufcient duct size. For example: 7” duct over 6” hole and loosely secured.
Check if duct is clogged or if damper unit (half-circular apper) is not installed correctly or opening properly.
A tight mesh on a side wall cap unit might also cause restriction to the air ow.