Installation Sheet

ACRYLIC PEDESTAL TUB
Acrylic Pedestal Tub Installation 5
6. The overflow tee (A) will be attached at the points
where the drain pipes intersect (B).
2. Move the tub away from the installation location so that
the plumbing can be installed. Place the drain pipe at the
appropriate height for the waste and overflow piping. To
determine this, you will need to temporarily fit your drain
pipe into the tub and measure from the floor to the center
of the drain pipe.
4. Next you will need to trim your drain and overflow pipes
to the appropriate sizes. Steps 5-8 will walk you through.
3. Carefully set the tub back into position and adjust the
tub feet as necessary until level. Once level, apply a
generous bead of silicone on the bottom of the feet.
This will prevent the tub from shifting after installation.
Tip: Plan for the bottom of the tub to sit approximately
1/8" above the finished floor so that the weight of the
tub, water, and bather are fully supported by the tub feet
rather than the tub walls.
5. To trim the drain and overflow pipes appropriately, you
will need to temporarily fit the overflow and drain
assemblies to the tub.
A
B