Installation Sheet

ACRYLIC PEDESTAL TUB
Acrylic Pedestal Tub Installation 3
7. Carefully turn the tub back over to its upright
position. Proceed to step 2 regarding tub
installation.
Important: Lift by the rim of the tub, Do not lift the
tub by the plinth.
STEP 2: TUB INSTALLATION
2. Move the tub away from the installation location so that
the plumbing can be installed. The drain pipe should extend
approximately 6” above the finished floor.
3. When the floor is finished, measure and cut the drain
pipe to the appropriate length for the type of drain that is
being used.
Proceed to the appropriate drain configuration to
complete rough-in and installation.
4. Carefully set the tub in position and adjust the
tub feet as necessary until level. Once level, apply a
generous bead of silicone on the bottom of the
feet. This will prevent the tub from shifting after
installation.
Tip: Plan for the bottom of the tub to sit
approximately 1/8" above the finished floor so that
the weight of the tub, water, and bather are fully
supported by the tub feet rather than the tub walls.
6 inches